Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » rack and pinion ps hoses
Viewing all articles
Browse latest Browse all 10

Ford Windstar Rack and Pinion Installation Instructions

0
0

The rack and pinion on a Ford Windstar is the steering rack that connects the wheels to the steering wheel. This rack is made up of a number of transferring parts and now have hydraulic seals held internally, and if any of these things fail, then the rack and pinion meeting will must be faraway from the Windstar so it may be rebuilt or replaced. Once that’s finished, the next step is to install the rack and pinion meeting, which takes about two hours to do.

Ford Windstar Rack and Pinion Installation Instructions

1. Elevate the front finish of the car with a jack and assist the body with two jack stands on each sides. Take away the wheels with a lug wrench. Slide underneath the Windstar and locate the power steering lines working out of the facility steering pump. Install the replacement O-rings into the ability steering line fittings with your hands. Place the mounting bolts for the rack and pinion into the meeting, then raise it up into the frame by means of the motive force aspect fender well. Bolt it in place using the 3/8-inch ratchet wrench and socket, then torque the bolts to 85 foot-kilos with the 3/8-inch torque wrench.
2. Install the power steering traces onto the rack and pinion with an open-finish wrench. Bolt the heat protect in place with the 3/8-inch ratchet wrench. Install the tie rod ends into the steering knuckles on either side using the 3/8-inch ratchet wrench, then install the cotter pins into the steering knuckle ball joints along with your fingers.
3. Set up the sway bar to the underside of the chassis with the 3/8-inch ratchet, extension and sockets. Put the jack beneath the rear of the vehicle’s subframe, which is subsequent to the steering rack. Use the jack to lift the subframe up to the physique till you may reattach the subframe bolts to the chassis. Torque the bolts to 85 foot-kilos with the 3/8-inch torque wrench.
4. Reinstall the exhaust flex tube to the exhaust using the 3/8-inch ratchet, extension and sockets. Set up the entrance wheels with the tire wrench. Reconnect the steering column to the rack and pinion utilizing the replacement pinch bolt and the 3/8-inch ratchet wrebch. Torque the bolts to 25 foot-pounds with the 3/8-inch torque wrench. Decrease the Windstar down off of the jack stands utilizing the jack.


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images